Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine: Oil level, checking
2007 Audi S8SECTION Engine: Oil level, checking
NOTE:
- Oil temperature at least 140 ° F (60 ° C).
- Vehicle must be in level position.
- After stopping engine, wait a few minutes to allow oil to flow back into oil pan.
- Pull out oil dipstick and wipe with clean rag. Replace dipstick and push down to stop.
- Pull out dipstick again and read oil level.
Markings on dipstick:
NOTE:
- Oil level must not exceed - a - mark on dipstick.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.