Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Brake light switch, removing and installing
2007 Audi S8SECTION Brake light switch, removing and installing
NOTE:
- Brake light switch must be removed for adjustment.
- To ensure secure installation, switch may only be installed once.
Removing
- disconnect electrical connection.
- Remove brake light switch by rotating it 45 ° toward left.
Installing
Installation is in reverse order of removal, with special attention to the following:
- Pull out plunger of brake light switch completely - arrow -.
- Insert switch with tabs - 1 - and - 2 - in designated retainers in assembly opening.
- Remove drivers side storage compartment: → 68 - INTERIOR EQUIPMENT .
NOTE:
- The brake pedal must not be actuated during installation.
- When installing brake switch, the plunger adjusts itself automatically.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.