Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSAUDI2007S8REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEFUEL DELIVERY5.2L - ENGINE MECHANICAL, ENGINE CODE(S): BSM13 - ENGINE - CRANKSHAFT, CYLINDER BLOCKPISTON AND CONNECTING ROD, DISASSEMBLING AND ASSEMBLINGPISTON AND CONNECTING ROD, COMPONENT OVERVIEWCONNECTING ROD, INSTALLED LOCATION

2007 Audi S8

Connecting rod, installed location

2007 Audi S8SECTION Connecting rod, installed location

Fig 1: Connecting Rod, Installed Location

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Molded tabs - arrows - at the beveled surfaces of the connecting rod pairs 1 and 2, 3 and 4, 5 and 6, 7 and 8 as well as 9 and 10 must point toward each other.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.