Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2007S8REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSELECTRICAL EQUIPMENT
2007 Audi S8
Electrical Equipment
2007 Audi S8SECTION Electrical Equipment
- 27 - Battery, Starter, Generator, Cruise control
- Contact Corrosion
- Battery
- Battery
- General Information
- Maintenance-Free Battery
- Battery, Disconnecting and Connecting
- Battery, Removing and Installing
- Battery, Testing
- Preparing for No Load Voltage Measurement
- Battery, Charging
- Battery, Preparing for Charging
- Battery, Preparing for Support Mode
- Battery Switch-Off Relay, Removing and Installing
- Battery Interrupt Igniter, Removing and Installing
- Energy Management Control Module, Removing and Installing
- Generator, Removing and Installing
- Generator, Testing and Servicing
- Starter, Removing and Installing
- Cruise Control System
- 90 - Instruments
- Instrument Cluster
- Instrument Cluster
- Instrument Cluster, Removing and Installing
- Instrument Cluster Multi-Pin Connectors, Contact Assignment
- Fuel Level Sensors, Connector Assignment
- Engine Coolant Temperature Sensor, Connector Assignment
- Engine Coolant Temperature Sensor, Connector Assignment
- Coolant Temperature Sensor Electrical Connector, 4.2L MPI, Disconnecting
- Coolant Temperature Sensor Electrical Connector, 4.2L FSI, Disconnecting
- Coolant Temperature Sensor Electrical Connector, 5.2L FSI, Disconnecting
- Coolant Temperature Sensor Electrical Connector, 6.0L MPI, Disconnecting
- Radio Frequency Controlled Clock Receiver, Removing and Installing
- Garage Door Opener Control Module, Removing and Installing
- Data Bus On Board Diagnostic Interface, Component Overview
- Data Bus On Board Diagnostic Interface, Removing and Installing
- Data Bus On Board Diagnostic Interface Connector
- Horn
- Instrument Cluster
- 92 - Windshield wiper and washer system
- Contact Corrosion
- Windshield Wiper System
- Windshield Wiper System
- Windshield Wipers, Bringing into Service Position
- Windshield Wiper Blades, Replacing
- Windshield Wiper Arms, Removing and Installing
- Windshield Wiper Arms, Adjusting
- Windshield Wiper Motor and Control Module, Removing and Installing
- Windshield Wiper Motor and Control Module, Replacing
- Rain/Light Recognition Sensor, without Lane Assist, Removing and Installing
- Rain/Light Recognition Sensor, with Lane Assist, Removing and Installing
- Windshield Washer System
- Headlamp Washer System
- Washer Fluid Lines
- 94 - Lights, Switches - Exterior
- Contact Corrosion
- Halogen Headlamps
- HID Headlamps
- HID Headlamps
- HID Headlamps, Usage and Safety Precautions
- HID Headlamps, Component Overview
- Headlamps, Removing and Installing
- Headlamps, Adjusting
- Preparing to Work on Headlamps
- HID Headlamp, Replacing
- HID Headlamp Ignition Coil, through 08.07, Removing and Installing
- HID Headlamp Ignition Coil, from 09.07, Removing and Installing
- High Beam Bulb, Replacing
- Daytime Running Lamp Bulb, Replacing
- Parking Lamp Bulb, Replacing
- High/Low Beam Switch-Over Solenoid, Removing and Installing
- Swivel Module Position Sensor and Dynamic Cornering Light Motor, Removing and Installing
- Turn Signal Bulb, Replacing
- Headlamp Beam Adjustment Motors, Removing and Installing
- HID Headlamp Control Module, Removing and Installing
- HID Headlamp Power Output Stages, Removing and Installing
- Headlamp Bracket, Replacing
- Side Marker Lamps
- Fog Lamps, through 08.07
- Fog Lamps, from 09.07
- Side Turn Signals, through 08.07
- Side Turn Signals, from 09.07
- Exterior Mirror Entry Lamps, through 08.07
- Exterior Mirror Entry Lamps, from 09.07
- Outside Door Handle Lamp
- Outer Tail Lamps, through 08.07
- Outer Tail Lamps, from 09.07
- Inner Tail Lamps, through 08.07
- Inner Tail Lamps, from 09.07
- High Mounted Brake Light
- License Plate Lamp
- Steering Column Switch Module
- Steering Column Switch Module
- Steering Column Switch Module, Component Overview
- Steering Column Switch Module, Removing and Installing
- Airbag Spiral Spring/Return Spring With Slip Ring, Removing and Installing
- Steering Angle Sensor, Removing and Installing
- Steering Column Electronic Systems Control Module, Removing and Installing
- Steering Column Electronic Systems Control Module, Front Side, Connector Assignment
- Steering Column Electronic Systems Control Module, Rear Side, Connector Assignment
- Turn Signal Switch, Removing and Installing
- Cruise Control Switch, Removing and Installing
- Windshield Wiper/Washer Switch, Removing and Installing
- Access/Start Authorization Switch
- Parking Aid
- Automatic Headlamp Range Control
- 96 - Lights, Switches - Interior, Anti-theft
- Contact Corrosion
- Switches
- Switches
- Instrument Cluster Button in Cover, Removing and Installing
- Instrument Panel Button, Removing and Installing
- Light Switch, Removing and Installing
- Steering Column Adjustment Switch, Removing and Installing
- Access/Start Authorization Button or Driver Identification Control Module, Removing and Installing
- Front Seat Heating Switch, Removing and Installing
- Rear Seat Heating Switch, Removing and Installing
- Glove Compartment Lamp Switch, Removing and Installing
- Light Recognition Sensor, Removing and Installing
- Humidity Sensor, without Lane Assist, Removing and Installing
- Humidity Sensor, with Lane Assist, Removing and Installing
- Garage Door Opener Control Head, Removing and Installing
- Rear Cigarette Lighter, Removing and Installing
- Rear Cigarette Lighter, with Rear A/C Display Control Head, Removing and Installing
- Mirror Adjustment Switch, Removing and Installing
- Power Window Control Head, Removing and Installing
- Window Regulator Switch, Removing and Installing
- Rear Window Switch, Removing and Installing
- Front Seat Memory Program Control Head, Removing and Installing
- Rear Lid Remote Control Lock Switch and Fuel Tank Lid Unlock Button Unit, Removing and Installing
- Seat Memory Lock-Out Button/Front Passenger Emergency Off Button, Memory Seat, Removing and Installing
- Front Passenger Seat Adjustment Switch, Removing and Installing
- Door Contact Switch, Removing and Installing
- Front Interior Locking Switches, Removing and Installing
- Rear Interior Locking Switches, Removing and Installing
- Passenger Compartment Monitoring Switch and Alarm System Off Switch, Removing and Installing
- Rear Lid Lock Button, Removing and Installing
- Trunk Lock/Alarm/Central Locking Switch, Removing and Installing
- 12 V Outlet in Long Center Console, Removing and Installing
- 12 V Outlet in Luggage Compartment, through 06.04, Removing and Installing
- 12 V Outlet in Luggage Compartment, from 06.04, Removing and Installing
- Anti-Theft Immobilizer
- Access/Start Authorization System
- Access/Start Authorization System
- Access/Start Authorization System, Component Overview
- Keyless Access Authorization System, Component Overview
- Keyless Access Authorization System Exterior Door Handle, Component Overview
- Front Door Handle Switch, Removing and Installing
- Rear Door Handle Switch, Removing and Installing
- Access/Start Authorization Control Module, Removing and Installing
- Interior Access/Start Authorization Antenna 1, Removing and Installing
- Interior Access/Start Authorization Antenna 2, Removing and Installing
- Interior Access/Start Authorization Antenna 3, Removing and Installing
- Luggage Compartment Access/Start Authorization Antenna, Removing and Installing
- Rear Bumper Access/Start Authorization Antenna, Removing and Installing
- Anti-Theft Alarm System with Ultrasonic Interior Monitoring
- Interior Lamps
- Interior Lamps
- Vanity Mirror Lamp, Removing and Installing
- Front Interior Lamp with Roof Electronics Control Module, through 08.07, Removing and Installing
- Front Interior Lamp with Roof Electronics Control Module, from 09.07, Removing and Installing
- Front Interior Lamp Bulbs, Replacing
- Front Reading Lamp Bulbs, Replacing
- Front Ambient Lighting LED, Removing and Installing
- Rear Interior/Reading Lamps with Rear Roof Module Control Head, through 08.07, Removing and Installing
- Rear Interior Lamp Bulb, through 08.07, Replacing
- Rear Reading Lamp Bulb, through 08.07, Replacing
- Rear Interior/Reading Lamps with Rear Roof Module Control Head, from 09.07, Removing and Installing
- Rear Interior Lamp Bulb, from 09.07, Replacing
- Rear Reading Lamp Bulb, from 09.07, Replacing
- Rear Ambient Lighting LED, Removing and Installing
- Illuminated Rear Vanity Mirror, Removing and Installing
- Rear Vanity Mirror Lamp, Removing and Installing
- Front Center Console Lamp, Removing and Installing
- Glove Compartment Lamp, Removing and Installing
- Door Opener Lamp Bulb, Removing and Installing
- Interior Door Lighting Strip, Removing and Installing
- Door Safety and Entry Lamp, Removing and Installing
- Front Footwell Lamp, Removing and Installing
- Rear Footwell Lamp, Removing and Installing
- Luggage Compartment Lamps, Removing and Installing
- Lane Change Assistance
- Lane Change Assistance
- Lane Change Assistance, Assembly Overview
- Lane Change Assistance Button, Removing and Installing
- Lane Change Assistance Warning Lamps, Removing and Installing
- Lane Change Assistance Control Modules, Removing and Installing
- Lane Change Assistance, Preparing for Calibration
- Lane Change Assistance Control Modules, Calibrating
- Heated Steering Wheel
- Trailer Hitch
- 97 - Wiring
- Contact Corrosion
- Relay and Fuse Carriers
- Relay and Fuse Carriers
- Component Protection
- Left Instrument Panel Fuse Holder, Removing and Installing
- Left CAN Cut-Off Connector, Removing and Installing
- Left Door Cut-Off Connector, Disconnecting
- Vehicle Electrical System Control Module, Removing and Installing
- Relay and Fuse Carrier behind Left Instrument Panel, Removing and Installing
- Driver Side Electronics Box, Removing and Installing
- Right Instrument Panel Fuse Holder, Removing and Installing
- Right CAN Cut-Off Connector, Removing and Installing
- Right Door Cut-Off Connector, Disconnecting
- Main Fuse Carrier, Right A-Pillar, Removing and Installing
- Relay Carrier in Front Right Footwell, Removing and Installing
- Vehicle Electrical System Control Module 2, Removing and Installing
- Fuse Holder in Left of Luggage Compartment, Removing and Installing
- Right Luggage Compartment Relay and Fuse Carrier, Removing and Installing
- Heated Windshield Control Module, Removing and Installing
- Front Door Ambient Lighting Voltage Converter, Removing and Installing
- Rear Door Ambient Lighting Voltage Converter, Removing and Installing
- Plenum Chamber E-Box, Removing and Installing
- Relay and Fuse Carrier in Plenum Chamber E-Box, Removing and Installing
- Wiring Harnesses and Connectors, Repairing
- Contact Housings and Connectors, Repairing
- Contact Housings, Releasing and Disassembling
- Contact Surfaces, Cleaning with Contact Surface Cleaning Set VAS 6410
- Antenna Wires, Repairing
- Fiber Optic Cable
- Vehicle Diagnosis, Testing and Information Systems
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.