Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Steering Fluid, Checking
-- Do not run engine and turn front wheels to straight ahead position.
Fluid Cold (Approximately 20 °C (68 °F))
-- Remove the cap.
-- Wipe dipstick off with a clean cloth.
-- Screw cap on hand-tight and unscrew again.
The cap must be fully screwed in order to obtain an accurate fluid level reading.
-- Check fluid level: Oil level must be within the -A- area.
Fluid at Operating State Temperature (Approximately 80 °C (176 °F))
-- Remove the cap.
-- Wipe dipstick off with a clean cloth.
-- Screw cap on hand-tight and unscrew again.
The cap must be fully screwed in order to obtain an accurate fluid level reading.
-- Check fluid level: Oil level must be within area -B-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.