Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSAUDI2007S6REPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEM5.2L - GENERIC SCAN TOOL - ON BOARD DIAGNOSTIC (OBD) - ENGINE CODE: BXA01 ON BOARD DIAGNOSTIC (OBD)DIAGNOSIS AND TESTINGENGINE CONTROL MODULE, REMOVING AND INSTALLINGENGINE CONTROL MODULE 2

2007 Audi S6

Engine Control Module 2

2007 Audi S6SECTION Engine Control Module 2

Special tools and workshop equipment required

Heat gun.

Removal

-- Remove the rubber seal from the plenum chamber cover -1-.

-- Remove the plenum chamber cover -2-.

Fig 1: Removing Rubber Seal And Plenum Chamber Cover

Courtesy of AUDI OF AMERICA, LLC

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.