Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2007RS4 QUATTRO SEDAN (8EC) V8-4.2L (BNS)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMSERVICE AND REPAIRPROCEDURES
2007 Audi RS4 Quattro Sedan (8EC) V8-4.2L (BNS)
Procedures
2007 Audi RS4 Quattro Sedan (8EC) V8-4.2L (BNS)SECTION Procedures
Ignition System, Servicing
=> [ Safety Precautions ] Ignition System, Servicing
=> [ Spark Plug Test Data ] Spark Plug Test Data
=> [ Camshaft Position Sensors 1 and 3, Checking ] Camshaft Position Sensors 1 and 3, Checking
=> [ Camshaft Position Sensors 2 and 4, Checking ] Camshaft Position Sensors 2 and 4, Checking
=> [ Camshaft Adjustment Valve 1 and Camshaft Adjustment Valve 1 (Exhaust), Checking ] Camshaft Adjustment Valve 1 and Camshaft Adjustment Valve 1 (Exhaust), Checking
=> [ Camshaft Adjustment Valve 2 and Camshaft Adjustment Valve 2 (Exhaust), Checking ] Camshaft Adjustment Valve 2 and Camshaft Adjustment Valve 2 (Exhaust), Checking
=> [ Knock Sensors 1 and 2, Checking ] Knock Sensors 1 and 2, Checking
=> [ Knock Sensors 3 and 4, Checking ] Knock Sensors 3 and 4, Checking
=> [ Ignition Coils 1 - 4, with Power Output Stage, Checking ] Ignition Coils 1 - 4, With Power Output Stage, Checking
=> [ Ignition Coils 5 - 8, with Power Output Stage, Checking ] Ignition Coils 5 - 8, With Power Output Stage, Checking
For all Ignition/Glow plug system component locations. Refer to Fuel Injection and Ignition Repair Information
For all Ignition/Glow plug system removal/installation procedures and torque specifications. Refer to Fuel Injection and Ignition Repair Information
Check the Technical Bulletins for information that may supersede any information included in this service information.
• All manufacturers special tools as well as common tools may contain a manufacturer specific part number. These tools may be substituted with an equivalent aftermarket tool or are available for purchase through Audi.
• Manufacturers special tools as well as common tools that contain a manufacturer specific part number may be referenced in the test procedure illustrations showing the tool use or installation. If the manufacturer specific tool is not being used, an equivalent aftermarket tool may be installed in the same manner as the manufacturers special tool.
• The manufacturers test box Test Box 105 Pin (VAG1598/42 ) is available for purchase or rental.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.