Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Mass Air Flow Sensor, Checking: Notes
Use only gold-plated terminals when servicing terminals in harness connector of Mass Air Flow (MAF) Sensor -G70-.
Special tools and workshop equipment required
- Multimeter.
- Wiring diagram.
Test requirements
- The Mass Air Flow (MAF) Sensor -G70- fuse OK.
- Battery voltage at least 12.5 volts.
- All electrical consumers such as, lights and rear window defroster, switched off.
- Vehicles with automatic transmission, shift selector lever into position "P" or "N".
- A/C switched off.
- Ground (GND) connections between engine/transmission/chassis OK.
- Coolant Temperature at least 80° C.
- Ignition switched off.
Test procedure
-- Perform a preliminary check to verify the customers complaint. Refer to GENERAL DIAGNOSIS .
Start diagnosis
-- Connect the scan tool.
-- Start engine and let it run at idle.
-- Using the scan tool, Check the air flow quantity of the Mass Air Flow (MAF) Sensor -G70- at idle:
| Diagnostic text | Specified value | |||
|---|---|---|---|---|
| Air flow quantity at Mass Air Flow (MAF) sensor | ||||
|
2.00 to 5.00 g/sec | |||
-- End diagnosis and switch ignition off.
If the specified value was obtained, but the DTC memory has a DTC concerning the Mass Air Flow (MAF) Sensor -G70- :
-- Check the voltage supply of the Mass Air Flow (MAF) Sensor -G70-.
If specified value was not obtained:
-- Check the wiring of the Mass Air Flow (MAF) Sensor -G70-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.