Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cooling System Overview
2007 Audi A3 Base, Automatic DCTSECTION Cooling System Overview
- Bolt
- 40 Nm
- Bolt
- 23 Nm
- Coolant Pipe
- Connecting Hose
- O-ring
- Replace
- Connecting Piece
- Bolt
- 10 Nm
- Retaining Clip
- O-ring
- Replace
- Coolant Temperature Sensor -G62-
- Connecting Hose
- Connecting Piece
- Connecting Hose
- Connecting Hose
- Connecting Hose
- Coolant Pipe
- Bolt
- 9 Nm
- Connecting Hose
- Coolant Pipe
- Bolt
- 10 Nm
- Coolant Distribution Housing
- With coolant thermostat
- Starts to open 87 °C (188 °F)
- Bolt
- 15 Nm
- Coolant Pump
- Removing and installing, refer to COOLANT PUMP
- Bolt
- 15 Nm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.