Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2007A3 BASE, AUTOMATIC DCTREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORGROUNDS
2007 Audi A3 Base, Automatic DCT
Electrical Component Locator: Grounds
2007 Audi A3 Base, Automatic DCTSECTION Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G12 | Left side of engine compartment. See Figure. |
| G43 (A) | Behind right kick panel. See Figure. |
| G44 (A) | Behind left kick panel. See Figure. |
| G51 | At right side of luggage compartment. See Figure. |
| G53 | Right side of rear lid. See Figure. |
| G61 | On left "C" pillar. See Figure. |
| G62 | On right "C" pillar. See Figure. |
| G607 | In left plenum chamber. See Figure. |
| G610 | Under front of center console. See Figure. |
| G638 (B) | Behind right kick panel. See Figure. |
| G639 (B) | Behind left kick panel. See Figure. |
| G655 (C) | On left headlight. See Figure. |
| G656 | On right headlight. See Figure. |
| G662 | On left "C" pillar. See Figure. |
| G671 (A) | On left front long member. See Figure. |
| G673 | On left front long member. See Figure. |
| G674 (B) | On left front long member. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.