SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2007A3 BASE, AUTOMATIC DCTREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSAIR CONDITIONING87 AIR CONDITIONINGDESCRIPTION AND OPERATIONA/C SYSTEM CONTROL AND REGULATION COMPONENTS OUTSIDE PASSENGER COMPARTMENTNOTES
2007 Audi A3 Base, Automatic DCT

A/C System Control And Regulation Components Outside Passenger Compartment: Notes

2007 Audi A3 Base, Automatic DCTSECTION Notes
NOTE:
  • Vehicles with automatically regulated A/C system, Climatronic Control Module -J255- evaluates the signals from various components and actuates the compressor via the A/C Compressor Regulator Valve -N280-.
  • Vehicles with manual climate control system, the A/C Control Module -J301- evaluates the signals from various components and actuates the A/C compressor via the A/C compressor regulator valve.
  • If there is a malfunction in the system, first check DTC memory of Climatronic control module / A/C control module using Vehicle Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.
  • If no fault is displayed, then read the measured value block for the Climatronic control module / the A/C control module and test the component using the "control diagnosis" function of the Vehicle Diagnosis, Testing and Information System VAS 5051 under "Guided Fault Finding".
  • Servicing operations on refrigerant circuit are described in REFRIGERANT CIRCUIT, SERVICING .
  • Perform the following work on completion of repair operations:

-- Check DTC memory of Climatronic control module / of A/C control module and erase any malfunctions displayed.

-- Check coding of Climatronic control module.

-- If necessary, check adaptation of Climatronic control module.

-- Perform basic setting of A/C system (Climatronic control module / A/C control module) using Vehicle Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.