Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Radio Frequency Controlled Clock Receiver
Removing
-- Remove the rear bumper cover. Refer to Removal and Installation .
-- Disconnect the connector on the radio frequency controlled clock receiver -J489- -item 1-.
-- Remove screws -2- and remove radio frequency controlled clock receiver.
Installing
Install in reverse order of removal, noting the following:
-- Install the rear bumper cover. Refer to Removal and Installation .
Tightening Specifications
| Component | Nm |
|---|---|
| Radio frequency controlled clock receiver to bumper | 2.5 |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.