Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2007A3 (8PA) L4-2.0L TURBO (BPY)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD, ENGINE
2007 Audi A3 (8PA) L4-2.0L Turbo (BPY)
Connecting Rod, Engine
2007 Audi A3 (8PA) L4-2.0L Turbo (BPY)SECTION Connecting Rod, Engine
Connecting Rod Bolts
Install new bolts
Tighten 30 Nm plus an additional 90°
Connecting Rod Bearing Shells
Axial play
New 0.10 to 0.30 mm
Wear limit 0.40 mm
Radial clearance
New 0.02 to 0.06 mm
Wear limit 0.09 mm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.