Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2007A3 (8PA) L4-2.0L TURBO (BPY)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRVEHICLE ELECTRICAL SYSTEM CONTROL MODULE
2007 Audi A3 (8PA) L4-2.0L Turbo (BPY)
Vehicle Electrical System Control Module
2007 Audi A3 (8PA) L4-2.0L Turbo (BPY)SECTION Vehicle Electrical System Control Module
Vehicle Electrical System Control Module
Removing
Observe notes on contact corrosion.
- If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or " Guided Functions".
- Select the function or path:
- Follow further instructions on display of (VAS 5051B).
- Switch off ignition and remove ignition key.
- Remove driver storage compartment.
- Release retaining springs - arrows - and remove Vehicle Electrical System Control Module (J519) - item 1 - down from base mount - 2 -.
• Shown with connectors removed in illustration.
- Press the connector clips - 1 - and - 2 - in - direction of arrow -.
- Unplug connectors.
• Shown with connectors removed in illustration.
Installing
Install in reverse order of removal, noting the following:
If the Vehicle Electrical System Control Module ( J519) was replaced, then is must be re-coded.
- Select the function or path:
- Follow further instructions on display of (VAS 5051B).
- Install driver storage compartment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.