Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSAUDI2007A3 (8PA) L4-2.0L TURBO (BPY)REPAIR AND DIAGNOSISDIAGRAMSCONNECTOR VIEWSSTEERING MOUNTED CONTROLS COMMUNICATION MODULE
2007 Audi A3 (8PA) L4-2.0L Turbo (BPY)
Steering Mounted Controls Communication Module
2007 Audi A3 (8PA) L4-2.0L Turbo (BPY)SECTION Steering Mounted Controls Communication Module
Steering Column Electronic Systems Control Module, Multi-Pin Connector Assignments
A Multi-pin connector, 4-pin, yellow, for airbag
B Multi-pin connector, 20-pin (black), for Vehicle Electrical System Control Module (J519)
Multi-pin connector, 20-pin
11 Powertrain CAN-Bus Low
12 Powertrain CAN-Bus High
13 Cruise control locked "OFF" (to ECM)
14 Convenience CAN-Bus High
15 Convenience CAN-Bus Low
16 "Parking lock" signal (from automatic transmission selector)
17 Switched positive - Terminal 15 to Vehicle Electrical System Control Module (J519)
18 Starter crank signal - Terminal 50 to Vehicle Electrical System Control Module (J519)
19 Battery positive (B+) - Terminal 30
20 Ground (GND) - Terminal 31
Additional systems, Steering Column Electronic Systems Control Module (J527) multi-pin connector assignments => Electrical Equipment 94 Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.