Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fastener Tightening Specifications
2005 Audi A6 3.2 TSECTION Fastener Tightening Specifications
| Components | Fastener Size | Nm |
|---|---|---|
| Driveshaft heat shield to transmission bolt | - | 25 |
| Intermediate bearing bolt | - | 25 |
| Lock plate to driveshaft bolt | - | 55 |
| Rear final drive gear oil plug | - | 45 |
| Audi A4, Audi Cabriolet and Audi A6 | ||
| Rear crossmember to rear final drive bolt | - | 40 |
| Shield to rear final drive bolt | - | 25 |
| Subframe bolt | - | 40 |
| Transmission support to rear final drive bolt | - | 40 |
| Audi A8 | ||
| Heat shield to rear final drive bolt | - | 25 |
| Rear tunnel brace to rear final drive bolt | - | 55 |
| Transmission support to rear final drive bolt 1 | - | 40 + 90° |
| Transmission support to subframe nut 1 | - | 40 |
|
||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.