Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Steering Pump: Removing
Special tools and workshop equipment required
- Hose Clamps Up to 25 mm Dia.3094
- Spanner Wrench3212
- Torque Wrench 5-50 NmVAG1331
- Torque WrenchVAG1783
- Used Oil Collection and Extraction DeviceVAG1782
- Spring Type Clip PliersVAS5024 A
- Drip Tray for VAS6100VAS6208
General Information
The power steering pump is not designed to be serviced. If there are customer complaints, the cause must be determined using a pressure and leak test. If there is a malfunction, replace the pump.
If the power steering fluid is low in the reservoir, check steering system for leaks.
If there are leaks in the area of the line connections, the lines/connections must first be inspected for leaks, tightened as necessary and wiped dry.
Power steering pump is delivered without oil. Therefore, Hydraulic Oil must be filled before installation and turned by hand. Otherwise, noises when driving or damage to power steering pump may occur.
Affects Vehicles with Air Suspension
-- Place the vehicle on a hoist. Refer to POSITIONING VEHICLE ON HOIST AND WHEELS .
Affects All Vehicles
-- Siphon hydraulic oil from reservoir using oil extraction deviceVAG1358 A or VAG1782.
-- Remove noise insulation. Refer to Description and Operation .
Remove power steering pump ribbed belt. Refer to POWER STEERING PUMP RIBBED BELT PULLEY .
-- Disconnect the Air Conditioning (A/C) compressor electrical wire connector -1-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.