SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2005A6 3.2 TREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATING, VENTILATION & AIR CONDITIONING87 AIR CONDITIONINGGENERAL INFORMATIONCLIMATRONIC CONTROL MODULE A/C CONTROL HEAD BASIC VERSION
2005 Audi A6 3.2 T

CLIMATRONIC Control Module A/C Control Head Basic Version

2005 Audi A6 3.2 TSECTION CLIMATRONIC Control Module A/C Control Head Basic Version
  • The Climatronic Control Module -J255- A/C control head Basic version -A- is available in the following variants (with or without buttons for heated seats, for vehicles with left or right-hand steering, with a temperature scale in degrees Celsius or degrees Fahrenheit).
    Fig 1: Identifying A/C System Components
    GWWA87-10044Courtesy of AUDI OF AMERICA, LLC
  • On the Climatronic Control Module -J255- A/C control head Comfort version -A-, both control knobs cannot be pulled off and replaced individually.
  • If the temperature and sunshine infrared sensor -B- produces a faulty measurement (installed only in the Climatronic Control Module -J255- A/C control head Basic version -A-), check the Climatronic Control Module -J255- A/C control head. The temperature and sunshine infrared sensor -B- has to be clean.
  • With the Climatronic Control Module -J255- A/C control head Basic version, air distribution is controlled automatically via a characteristic curve when rotary switch -C- is in position A. Fresh air blower speed is automatically regulated when rotary switch -D- is in position A.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.