Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2005A6 3.2 TREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESTIRE PRESSURE MONITOR SYSTEMSTPMS RESET PROCEDURESNOTES
2005 Audi A6 3.2 T
TPMS Reset Procedures: Notes
2005 Audi A6 3.2 TSECTION Notes
NOTE:
Whenever tire pressures are adjusted, the adjusted pressure has to be stored again. See STORING TIRE INFLATION PRESSURES . If tire or tire pressure sensor was changed, the TPMS must be initialized. See WHEEL CHANGE INITIALIZATION .
When the tire pressure warning light illuminates and warning message appears, immediately check air pressure of all tires and adjust to the specified pressure. Store new pressures. Ensure warning indicators go out.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.