Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2005A6 3.2 TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (4.2L V8 5V GENERIC SCAN TOOL, ENGINE CODE(S): BNK)38 AUTOMATIC TRANSMISSION - GEARS, HYDRAULIC CONTROLSTRANSMISSION CONTROL MODULE (TCM) J217TRANSMISSION CONTROL MODULE (TCM) J217, REPLACING
2005 Audi A6 3.2 T
Transmission Control Module (TCM) J217, replacing
2005 Audi A6 3.2 TSECTION Transmission Control Module (TCM) J217, replacing
WARNING: This page is about a different variant/trim than selected.
NOTE:
- The Transmission Control Module (TCM) J217 is a component of the mechatronic unit in the transmission and cannot be replaced separately.
- To achieve optimal anti-theft protection for the vehicle, an anti-theft immobilizer was installed. The anti-theft immobilizer is a system for enabling/locking the Transmission Control Module (TCM) J217.
- So that this system cannot be circumvented, it is necessary to perform adaptation of the anti-theft immobilizer using the Vehicle Diagnosis Service Syst. VAS5052 in the On Board Diagnostic (OBD) function.
- If the Transmission Control Module (TCM) J217 must be replaced, the vehicle may be taken to the nearest Audi dealership for instructions on obtaining a Vehicle Diagnosis Service Syst. VAS5052.
Work procedure
Check control module identification of the previous Transmission Control Module (TCM) J217 as follows:
- Connect Vehicle Diagnosis Service Syst. VAS5052. → Diagnostic tester, connecting .
- Switch ignition on.
- In diagnostic function "address word 33 - OBD" select "Diagnostic mode 9: Vehicle information."
- Select "Test-ID 04: Calibration identification".
- The Transmission Control Module (TCM) J217 identification will be displayed, e.g.: 09G27750 L 0301
- End diagnosis and switch ignition off.
- Replace mechatronic unit in transmission. → 38 - AUTOMATIC TRANSMISSION - GEARS, HYDRAULIC CONTROLS .
- Check identification of the new Transmission Control Module (TCM) J217 to ensure it matches the old Transmission Control Module (TCM) J217.
- Code Transmission Control Module (TCM) J217. → Diagnostic mode 9: Vehicle information .
- Generate readiness code. → Readiness code, generating .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.