Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Mode 04 - Reset/Delete Diagnostic Data
2005 Audi A6 3.2 TSECTION Diagnostic Mode 04 - Reset/Delete Diagnostic Data
WARNING: This page is about a different car, the 2011 Audi A6, 2010 Audi A6, 2009 Audi A6, 2008 Audi A6, and 2007 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostic Mode 04 is used to reset or delete the following stored information:
- All emission related malfunctions in the DTC memory.
- The operating conditions at which a malfunction was stored will be reset.
- All adaptation values.
- The test results of all diagnostic functions.
NOTE:
- Depending on scan tool and protocol used, diagnostic mode 04 and the information provided may be referred to by a different name.
Procedure
- Connect the scan tool.
- Switch the ignition to the "ON" position.
- Select "Diagnostic Mode 03: Interrogating fault memory ".
- Then select "Mode 4: Reset/delete diagnostic data".
The scan tool will display: "Diagnostic data are being erased".
- Switch the ignition off.
- End of diagnosis.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.