Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Intake Manifold Assembly Overview
2005 Audi A6 3.2 TSECTION Intake Manifold Assembly Overview
WARNING: This page is about a different car, the 2011 Audi S6, 2010 Audi S6, 2009 Audi S6, 2008 Audi S6, and 2007 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
- Intake Flap Motor -V157-
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Variable Intake Manifold Runner Motor -V183-
- Bolt
- 2.5 Nm
- Intake Manifold Runner Position Sensor -G336-
- Right cylinder bank
- After replacing, perform "Adaptation" in "Guided Fault Finding" Vehicle diagnostic, testing, and information system - VAS 5051B-.
- Gasket
- Replace if damaged
- Open side faces Intake Manifold Runner Position Sensor -G336-
- Intake manifold
- Removing and installing, refer to Intake Manifold .
- Gasket
- Replace
- Gasket
- Replace
- Throttle valve control module -J338-
- After replacing, perform "Adaptation" in "Guided Fault Finding" vehicle diagnostic, testing, and information system -VAS 5051B-.
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Air duct
- Gasket
- Replace
- Throttle Valve Control Module 2 -J544-
- After replacing, perform "Adaptation" in "Guided Fault Finding" vehicle diagnostic, testing, and information system -VAS 5051B-.
- Bolt
- 9 Nm
- Bracket
- O-ring
- Replace
- Supports with coolant connection
- For crankcase ventilation
- Bolt
- 9 Nm
- Bolt
- Replace
- First tightening: 8 Nm
- Second tightening: 9 Nm and tighten another 90 degrees
- Gasket for intake manifold
- Replace
- Mounting pins
- 2 pieces
- Check availability
- Gasket
- Replace if damaged
- Open side faces Intake Manifold Runner Position Sensor 2 -G512-
- Intake Manifold Runner Position Sensor 2 -G512-
- Left cylinder bank
- After replacing, perform "Adaptation" in "Guided Fault Finding" vehicle diagnostic, testing, and information system -VAS 5051B-.
- Bolt
- 2.5 Nm
- Circlip
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.