SAE P1xxx-DTCs: Transmission

2005 Audi A6 3.2 TSECTION Transmission
WARNING: This page is about a different car, the 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
DTC Error Message Diagnostic Procedure Monitor Strategy Malfunction Criteria and Threshold Value Secondary Parameters with Enable Conditions Monitoring Time Length Frequency of checks, MIL Illum
P1702 Malfunction cannot activate control module replacement function, since another malfunction with equal priority is present Rationality Check. SW functions: actuating solenoid valves colliding with 2 substitute functions with same priority as driven solenoid valves that have short circuit to supply or interruption Β  0.02 Seconds
  • Continuous
  • 2 DCY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.