Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2005A6 3.2 TREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSIS3.2L - FUEL INJECTION IGNITION, ENGINE CODE(S): BKH24 - FUEL INJECTION SYSTEMSIMOS FUEL INJECTION SYSTEM, SERVICINGENGINE CONTROL MODULE (ECM), REMOVING AND INSTALLINGREMOVING
2005 Audi A6 3.2 T
Engine Control Module (ECM), removing and installing: Removing
2005 Audi A6 3.2 TSECTION Removing
- If engine control module (ECM) was replaced, select diagnostic object "Replacing engine control module (ECM)" in "Guided Fault-Finding".
- Turn ignition and remove ignition key.
- Remove rubber seal - 1 - for plenum chamber cover.
- Remove plenum chamber cover - 2 -.
- Pry off caps on wiper arms using a screwdriver.
- Loosen nuts - arrows - by several turns.
- Loosen wiper arms by gently rocking wiper arm. Remove nuts and remove wiper arms.
NOTE:
- If wiper arm cannot be removed in this way, use a standard puller.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.