Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Coolant Temperature (ECT) Sensor G62 Connector assignment: Notes
2005 Audi A6 3.2 TSECTION Notes
Special tools, testers and auxiliary items required
- Assembly tool T10118
Preparation
- Disconnect electrical harness connector at Engine Coolant Temperature (ECT) Sensor G62 ; procedure:
- Vehicles with 3.2l FSI engines.
- Vehicles with 4.2l MPI engine.
- Vehicles with 4.2l FSI engine.
- Vehicles with 5.2l FSI engine.
Terminal assignment of the 2-pin harness connector at Engine Coolant Temperature (ECT) Sensor G62
- Sensor ground (GND)
- Wire connection from Engine Coolant Temperature (ECT) Sensor G62 to engine control module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.