Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2005A6 3.2 TREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORMISCELLANEOUS
2005 Audi A6 3.2 T
Electrical Component Locator: Miscellaneous
2005 Audi A6 3.2 TSECTION Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location |
|---|---|
| Alarm Horn | Left rear of vehicle. See Figure . |
| Antenna For Tire Pressure Check (Left Front) | In left front wheel well. See Figure . |
| Antenna For Tire Pressure Check (Left Rear) | In left rear wheel well. See Figure . |
| Antenna For Tire Pressure Check (Right Front) | In right front wheel well. See Figure . |
| Antenna For Tire Pressure Check (Right Rear) | In right rear wheel well. See Figure . |
| Coolant Fan Control (FC) Series Resistance | Left front of engine compartment. See Figure . |
| High Tone Horn | Left front of engine compartment. See Figure . |
| Ignition Coil | Front of engine compartment. See Figure . |
| Low Tone Horn | Right front of vehicle. See Figure . |
| Passenger's Airbag Igniter 1 | Behind right side of dash. See Figure . |
| Power Output Stage | Front of engine compartment. See Figure . |
| Seat Belt Tensioner Igniter (Left) | Base of left "B" pillar. See Figure . |
| Seat Belt Tensioner Igniter (Right) | Right "B" pillar. See Figure . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.