Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2005A4 QUATTRO, 4D SEDAN, 3.2 GREPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEM3.2L - GENERIC SCAN TOOL, ENGINE CODE: BKHST - GENERIC SCAN TOOLDIAGNOSTIC MODESDIAGNOSTIC MODE 06: CHECKING TEST RESULTS OF COMPONENTS THAT ARE NOT CONTINUOUSLY MONITOREDTEST-ID 167 ($A7): MIS-FIRE CYLINDER 6 DATA
2005 Audi A4 Quattro, 4D Sedan, 3.2 G
Test-ID 167 ($A7): Mis-Fire Cylinder 6 Data
2005 Audi A4 Quattro, 4D Sedan, 3.2 GSECTION Test-ID 167 ($A7): Mis-Fire Cylinder 6 Data
- Connect the diagnostic tester.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 167 ($A7)".
- Select the desired "Test-ID (TID)" or "Hex-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 11 ($0B) | P0306 | Burn misfire cylinder 6 average value over 10 driving cycles. | 0 | 65535 (counts) | Refer to DTC P0306 in Ignition system . |
| 12 ($0C) | P0306 | Burn misfire cylinder 6 during this driving cycle. | 0 | 65535 (counts) | Refer to DTC P0306 in Ignition system . |
- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.