Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2005A4 BASE, 4D SEDAN, 3.0 TREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSCOMMUNICATION91 - COMMUNICATIONNAVIGATION SYSTEM IV (BNS 4.0)FUNCTION SELECTOR SWITCH II E272 , REMOVING AND INSTALLING
2005 Audi A4 Base, 4D Sedan, 3.0 T
Function Selector Switch II E272 , removing and installing
2005 Audi A4 Base, 4D Sedan, 3.0 TSECTION Function Selector Switch II E272 , removing and installing
- Turn off all electrical components.
- Remove ignition key.
Removing
- Open cigarette lighter cover - 2 -.
- Press Function Selector Switch II E272 - 1 - out of installation opening from below as shown in illustration.
- Disconnect connector at Function Selector Switch II E272.
Installing
- Install in reverse order.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.