Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
ABS system components (front axle), removing and installing: Notes
2004 Audi A8SECTION Notes
1 - ABS wheel speed sensor
- Before inserting sensor, clean inner surface of fitting hole and coat with grease G 000 650
- Replacing
2 - Socket head bolt
- Torque specification, 18 Nm
3 - Drive axle
4 - Wheel hub with wheel bearing
5 - Socket head bolt
- Replace after each removal → 40 - FRONT SUSPENSION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.