Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Parking Aid Control Module, Removing and Installing
2004 Audi A8SECTION Parking Aid Control Module, Removing and Installing
Removing
- If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or "Guided Functions".
- Switch off ignition and remove ignition key.
- Remove left luggage compartment side trim cover - arrows -.
- Remove nuts - arrows -.
- Disconnect connectors - 2 -.
- Remove Parking Aid Control Module J446 - 1 -.
Installing
Install in reverse order.
Tightening torque
| Component | Nm |
|---|---|
| Control module to chassis | 1.8 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.