Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2004A6 QUATTRO SEDAN (4B2) V8-4.2L (AWN)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL TESTINGWITH GENERIC SCAN TOOLSCAN TOOL CONNECTING AND INITIAL CHECKS
2004 Audi A6 Quattro Sedan (4B2) V8-4.2L (AWN)
Scan Tool Connecting and Initial Checks
2004 Audi A6 Quattro Sedan (4B2) V8-4.2L (AWN)SECTION Scan Tool Connecting and Initial Checks
Connect Diagnostic Tester
Special tools and equipment
- Vehicle Diagnostic and Information System VAS 5052 with diagnostic wire VAS 5052/3
Test requirements:
- Fuses for engine electronics OK
- Ground (GND) connections at engine and transmission OK
- Battery voltage at least 12.7 V
- Parking brake engaged.
- Vehicles with automatic transmission: Selector lever in position "P" or "N".
- Electrical consumers switched off (radiator fan must NOT run during test).
- A/C switched off.
Work procedure
- Switch ignition off.
- Connect Vehicle Diagnostic and Information System VAS 5052 with diagnostic wire VAS 5052/3.
CAUTION: Observe safety precautions.
NOTE: If a malfunction message is displayed: See Operating instructions for Vehicle Diagnostic and Information System VAS 5052
Depending on the desired mode "Selectable diagnostic modes" table: Selectable Diagnostic Modes Under Address Word 33-OBD
- Switch ignition on.
or
- Start engine.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.