Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2004A6 QUATTRO SEDAN (4B2) V8-4.2L (AWN)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURES5 SPEED AUTOMATIC 01VREAD MEASURING VALUE BLOCK (SCAN TOOL FUNCTION 08)FOR TRANSMISSIONS WITH HYDRAULIC CONTROL E18/2
2004 Audi A6 Quattro Sedan (4B2) V8-4.2L (AWN)
For Transmissions With Hydraulic Control E18/2
2004 Audi A6 Quattro Sedan (4B2) V8-4.2L (AWN)SECTION For Transmissions With Hydraulic Control E18/2
Read Measuring Value Block (scan tool function 08) for transmissions with hydraulic control E18/2
Notes: For transmissions with hydraulic control E17, "Read Measuring Value Block".
CAUTION: To avoid risk of accident during measuring and test drives, not the safety precautions.
Procedure
^ Connect VAS5051 tester or VAG 1551 scan tool and select Transmission Control Module (TCM) using "address word" 02.
Ignition must remain switched on for this.
Indicated on display
^ Press PRINT button to turn on Scan Tool (ST) printer. Indicator lamp in button must light up.
^ Press buttons -0- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.
When indicated on display:
^ Enter desired display group number =display group overview.
^ Confirm input using the -Q- button.
Indicated on display (example) for display group 001:
^ Display can be printed out on the paper roll when printer is switched on.
^ To switch to a different display group, proceed as follows:
^ If specified values are obtained in all display fields, press (arrow) button.
Indicated on display (function selection):
Display Group 001 - 004:
Display Group 005 - 008:
Display Group 009 - 125:
Overview of selectable display group numbers for transmission with hydraulic control E18/2
Notes:
^ When the printer is switched on, the contents of the display will be printed out on the scan tool log.
^ If specified values are not obtained in all display fields:
^ Press (arrow) button.
Indicated on display
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.