Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2004A6 QUATTRO SEDAN (4B2) V8-4.2L (AWN)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSELECTRONIC THROTTLE CONTROL MODULELOCATIONS
2004 Audi A6 Quattro Sedan (4B2) V8-4.2L (AWN)
Electronic Throttle Control Module: Locations
2004 Audi A6 Quattro Sedan (4B2) V8-4.2L (AWN)SECTION Locations
Overview Of Component Locations
Component Locations Overview:
10 Throttle valve control module -J338-
- With throttle drive (power accelerator actuation) -G186-, angle sensor -1- for throttle drive (power accelerator actuation) -G187-, and angle sensor -2- for throttle drive (power accelerator actuation) -G188-
- When replacing, perform adaptation, for this purpose switch on ignition for at least 20 seconds without starting engine or depressing accelerator pedal
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.