Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2004A6 QUATTRO SEDAN (4B2) V8-4.2L (AWN)REPAIR AND DIAGNOSISDIAGRAMSELECTRICAL DIAGRAMSHEADLAMP ALIGNMENT CONTROL MODULEHEADLIGHT BEAM ADJUSTING CONTROL MODULE (EXCEPT AWD)
2004 Audi A6 Quattro Sedan (4B2) V8-4.2L (AWN)
Headlight Beam Adjusting Control Module (Except AWD)
2004 Audi A6 Quattro Sedan (4B2) V8-4.2L (AWN)SECTION Headlight Beam Adjusting Control Module (Except AWD)
For information regarding diagrams for the Headlight Beam Adjusting Control Module (Except AWD), please refer to Suspension Control (Automatic - Electronic Level) Diagrams.
Diagram 19\5 (Track 29-42)
Diagram 19\6 (Track 43-56)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.