VAG 1551 Scan Tool, Connecting and Entering Address Word

VAG 1551 scan tool, connecting and entering address word

Note: The VAG 1552 scan tool or VAS 5051 vehicle diagnostic, testing and information system can be used instead of the VAG 1551 scan tool, however VAG 1552 scan tool does not have the facility for printing out the information in the display.

^ Observe test requirements for the system concerned.





^ With ignition switched off, connect scan tool to the diagnostic connector using VAG 1551/313 cable. The diagnostic connector is under the dashboard on the left side.





Indicated on display
1 Is displayed alternately

Note:
^ if the display remains blank, check connections of diagnostic connector
^ Refer to Wiring Diagrams
^ The PRINT button is used for switching on the printer (the indicator lamp in the button comes on when the printer is switched on).
^ Depending on the program, additional operating information can be printed out by pressing HELP button of VAG 1551 scan tool.





- Switch on ignition.
- Switch on printer by pressing PRINT button of scan tool.
- Press button -1- for "Rapid data transfer" operating mode.





Indicated on display

Note: The address word selects the control module of the on-board system that you wish to test with the scan tool. It is made up of two digits, which are given in the relevant sections of this Manual.

For instance, press buttons -0- and -3- to enter the address word for "Brake electronics".





Indicated on display
- Press -Q- button to confirm input.





Indicated on display after entering address word 03

Note: If an error occurs in the diagnostic communication between the scan tool and the control module, the display will show one of the four following messages:





- Press HELP button to obtain a print-out of the possible causes of the error.





- Test diagnostic wiring ("K" wire).

- Refer to Wiring Diagrams
- Test power supply and Ground (GND) connection to ABS control module (w/EDL) -Jl04-.





Indicated on display
- Repair error
- Refer to Wiring Diagrams,
- After repairing possible causes of error, enter address word 03 for brake electronics once again and confirm with -Q- button.





If the diagnostic communication between the scan tool and the control module is established and works properly, the display will now show the control module identification (X), the system designation (Y), the hardware and software version (Z), the coding (V) and the workshop code (W).

Note:
^ The (arrow) button is used for moving forward within the program
^ The control module index can only be changed by installing a new control module
^ Refer to Parts Supplier
^ If the control module identification number does not appear in the display, check diagnostic wiring

Refer to Wiring Diagrams
- Press (arrow) button.





Indicated on display