Adaptation (Function 10)

Adaptation (Function 10)

Requirements:
- Connect VAG 1551 Scan Tool (ST).
- Switch on ignition.

Implementing function "10 - Adaptation"

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press keys 1 and 0 to select "Adaptation" function.
- Confirm entry with Q key.

Indicated on display:


Rapid data transfer Q
10- Adaptation


- Confirm entry with Q key.

Indicated on display:


Adaptation
Enter channel number XX


- Enter desired adaptation channel.
- Confirm entry with Q key.


NOTE: After changing adaptation value/following termination of an adaptation channel, function "10 - Adaptation" must be implemented again to select a different adaptation channel.


Matching of remote control keys by way of adaptation function
- Switch on ignition.

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press keys 1 and 0 to select "Adaptation" function.

Indicated on display:


Rapid data transfer Q
10 - Adaptation


- Confirm entry with Q key.

Indicated on display:


Adaptation
Enter channel number XX


- Press keys 2 and 1 (to select "Channel 21".


NOTE:
- Wrong entries can be corrected by pressing C key.


- Confirm entry with Q key.

Indicated on display:


Channel 21 Adaptation 0 ->
Key Setting <-1 3->


Top line shows selected channel and memory position for key to be matched. Select desired memory position of key to be matched with keys 1 and 3 (or on V.A.G 1552 with keys (Down arrow) and (Up arrow)).

- Third memory position is selected in example.

Indicated on display:


Channel 21 Adaptation 3 ->
Key Setting <-1 3->


- Press remote control opening/closing button.

Indicated on display:


Channel 21 Adaptation 3 Q
Key Recognized


Display "Setting" switches to "Recognized" following recognition of remote control command.

- Confirm entry with Q key.

Indicated on display:


Channel 21 Adaptation 3 Q
Store altered value?


- Confirm entry with Q key.

Indicated on display:


Channel 21 Adaptation 3 ->
Altered value stored


- Press key.

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press keys 0 and 6 to select "End Output" function.
- Switch off ignition and remove ignition key.
- Check function of newly matched remote control key.


NOTE:
- Successful adaptation can be established by way of Read Measuring Value Block function (function 08), display group number 007.
- Care is to be taken to ensure that new keys are always matched to vacant memory positions. If use is made of a memory position already occupied, the matched remote control key already allocated to this memory position will no longer function.
- A maximum of four keys can be matched.