Vehicles with 5-valve 6-cylinder gasoline engine

The following list pertains to Fig 1.

1. Expansion hose 
   • Partial section with line, goes to steering gear
2. Hex bolt, 6 Nm 
3. Hex bolt, 9 Nm 
4. Ignition coils with brackets 
5. Power steering pump 
   • Before installing, fill with power steering fluid. See POWER STEERING / OIL CIRCULATION FOR 6-CYLINDER ENGINE , Notes:
   • Check delivery pressure. See DELIVERY PRESSURE OF POWER STEERING PUMP, CHECKING .
   • Removing and installing, see POWER STEERING PUMP, REMOVING AND INSTALLING 
6. Clamp 
   • Always replace
   • Tighten using VAG1275
7. Intake hose 
   • Marking -P- faces toward pump
8. Line for intake hose 
9. Socket head bolt, 22 Nm 
   • Rear mount for power steering pump to bracket
10. Bushing, slotted 
    • Used to balance out tolerances
11. Socket head bolt, 22 Nm 
    • Mounting of power steering pump bracket to crankcase
12. Socket head bolt, 22 Nm 
    • Mounting of power steering pump bracket to crankcase
13. Socket head bolt, 22 Nm 
    • Front mounting of power steering pump to bracket
14. Bracket for power steering pump 
15. Socket head bolt, 22 Nm 
    • Use 3212 special tool to counterhold when loosening or tightening
16. Belt pulley 
17. Seal 
    • Always replace
18. Banjo fitting, 47 Nm 
Fig 1: View Of Power Steering Pump Assembly (6-Cylinder Engine)
Courtesy of AUDI OF AMERICA, INC.