Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSAUDI2004A4 BASE, 4D SEDAN, 3.0 TREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSON BOARD DIAGNOSTIC (OBD)AUTOMATIC CLIMATE CONTROL SYSTEM, ON BOARD DIAGNOSTIC (OBD)END OUTPUT (FUNCTION 06)PROCEDURE

2004 Audi A4 Base, 4D Sedan, 3.0 T

End Output (function 06): Procedure

2004 Audi A4 Base, 4D Sedan, 3.0 TSECTION Procedure

Indicated on display of VAS 5051:

Select "06 - End output" function.

Fig 1: VAS 5051 Scan Tool Display - End Output (1 Of 2)
Courtesy of AUDI OF AMERICA, INC.
Wait until this display (menu) is shown on the VAS 5051 display.
Switch off ignition and disconnect diagnostic cable.

Fig 2: VAS 5051 Scan Tool Display - End Output (2 Of 2)
Courtesy of AUDI OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.