Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2001A6 AVANT QUATTROREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSSERVICING - A/T (01V)
2001 Audi A6 Avant Quattro
Servicing - A/T (01V)
2001 Audi A6 Avant QuattroSECTION Servicing - A/T (01V)
- Application
- Identification
- Lubrication
- On-Vehicle Repairs
- Adjustments
- Removal & Installation
- Notes
- A/C Control Head
- A/C Control Head & Radio Trim Section
- ATF Lines
- ATF Auxiliary Cooler
- Center Console, Front Section
- Center Console, Rear Section
- Differential Cover "O" Ring
- Differential/Transaxle Housing Double Sealing Ring
- Output flang/driveshaft oil seal, replacing
- Front Ash Tray (Chorus & Concert Radios)
- Front Final Drive Housing Cover Gasket
- Internal Oil Line
- Left Drive Flange
- Left Drive Flange Ball Bearing
- Locking Cable
- Radio (Chorus/Symphony)
- Radio (Concert)
- Right Drive Flange Sealing Ring
- Securing Spring For Locking Cable
- Selector Lever Handle
- Selector Lever Cable
- Selector Shaft Oil Seal
- Transaxle Fluid Temperature Sensor
- Transaxle Oil Pan & ATF Screen
- Transaxle Range Switch
- Transaxle Rpm Sensor
- Transaxle Vehicle Speed Sensor
- Transaxle Wiring Harness
- Vehicle Speed Sensor
- Valve Body Assembly
- Torque Specifications
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.