Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2001A6 AVANT QUATTROREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSOVERHAUL - A/T 01VGENERAL REPAIR INSTRUCTIONSO-RINGS, SEALS, GASKETS
2001 Audi A6 Avant Quattro
O-Rings, Seals, Gaskets
2001 Audi A6 Avant QuattroSECTION O-Rings, Seals, Gaskets
- Always replace O-rings, seals and gaskets.
- After removing O-rings, check contact surface on housing or shaft for removal dependent burrs or damage.
- Coat O-rings with ATF at outside circumference and at sealing lip for installation.
- Coat O-rings with ATF or Vaseline when installing , to prevent pinching of the rings during installation.
- Do not use any other lubricants in ATF area. Otherwise malfunctions of the hydraulic transmission control may occur.
- The open side of the oil seals faces the fluid to be sealed in.
- Check and if necessary top up transmission oil or ATF fluid after installing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.