Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Key Replacement Or Addition (Customer Supplied 2 Or More Valid Keys)
2001 Audi A6 Avant QuattroSECTION Key Replacement Or Addition (Customer Supplied 2 Or More Valid Keys)
- Cut new transponder equipped key(s). Using 1st key, turn ignition to ON position, then to LOCK position 5 times. Turn 1st key to ON position. SECURITY light should illuminate. Turn 1st key to LOCK position. SECURITY light should go out.
- Using 2nd key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn 2nd key to LOCK position and remove key.
- Repeat step 2 with 1st key. Repeat step 2 with new key. Repeat step 2 with each new or valid key, up to 8 keys total. Wait 30 seconds, program will quit automatically.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.