Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSAUDI2001A6 AVANT QUATTROREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (SUSPENSION - REAR, AWD)REMOVAL & INSTALLATIONSTRUT ASSEMBLYREASSEMBLY

2001 Audi A6 Avant Quattro

Strut Assembly: Reassembly

2001 Audi A6 Avant QuattroSECTION Reassembly

WARNING: This page is about a different variant/trim than selected.

To assemble, reverse disassembly procedure. Ensure spring ends are against rubber stops. See Fig 1 .

Fig 1: Positioning Spring In Strut Assembly (Lower Spring End Shown)
Courtesy of VOLKSWAGEN UNITED STATES, INC.
Ensure that upper strut mount is aligned as specified. See Fig 2 . Using NEW piston rod nut. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .

Fig 2: Checking Alignment Of Upper Strut Mount

Courtesy of AUDI OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.