Vibration damper, removing and installing: Installing

2001 Audi A6 Avant QuattroSECTION Installing
WARNING: This page is about a different car, the 2005 Audi allroad, 2004 Audi allroad, and 2003 Audi allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order, note the following:

  • Make exclusive use of genuine bolts when installing vibration damper. See Parts catalog.
    • Vibration damper can only be installed in one position (pay attention to dowel sleeve)
  • Install ribbed belt. See INSTALLINGΒ .
  • Install lock carrier with attachments.

    See LOCK CARRIER WITH ATTACHMENTS, REMOVING AND INSTALLING .

  • Allow stop for torque reaction support to settle on rubber buffer for torque reaction support and tighten bolts (arrows) to 28 Nm.
    Fig 1: Locating Torque Reaction Support Bolts
    G02720930Courtesy of AUDI OF AMERICA, INC.
  • Install front bumper.

    See FRONT BUMPER .

  • Adjust headlights.

    See HEADLIGHTS, ADJUSTING or HEADLIGHTS, ADJUSTING .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.