Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Brake light switch (rectangular housing), removing and installing
2001 Audi A6 Avant QuattroSECTION Brake light switch (rectangular housing), removing and installing
Brake light switch with spring clip mount.
- Brake pedal impact surface
- Spring clip
- Pedal bracket
- Brake light switch -F-
- Dimension: max. 1.2 mm to min. 0.5 mm
NOTE:
To ensure a secure fit, the switch may only be installed once.
- Press spring clip -2- into pedal bracket opposite direction of travel. See Fig 1.
- Guide switch -4- into installed spring clip -2- and press/thread it in until stop.
NOTE:
Do not pre-tension brake pedal!
- Check dimension -a- using feeler gauge and twist brake light switch to dimension -a- if necessary. See Fig 1.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.