Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2001A6 AVANT QUATTROREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE SYSTEM - ABSABS FRONT AXLE COMPONENTS, REMOVING AND INSTALLINGROTOR, CHECKING
2001 Audi A6 Avant Quattro
Rotor, checking
2001 Audi A6 Avant QuattroSECTION Rotor, checking
- Remove wheel bolts.
- Raise vehicle.
- Remove wheel.
- Remove ABS wheel speed sensor out of wheel bearing housing.
- Inspect rotor for signs of damage or dirt.
NOTE:
- If rotor is damaged or dirty remove drive axle. If damage, replace outer CV joint together with rotor.
- The outer CV joint is supplied with the rotor as a replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.