Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Function Mode 06: Exiting On-Board Diagnostics
When RAPID DATA TRANSFER SELECT FUNCTION XX is displayed, press 0 then 6 (06). RAPID DATA TRANSFER 06-END OUTPUT will be displayed. Press "Q" key to confirm input. RAPID DATA TRANSFER INSERT ADDRESS WORD XX will be displayed. Turn ignition off. Disconnect scan tool and install data link connector cover.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.