Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2001A6 AVANT QUATTROREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOWSREMOVAL & INSTALLATIONPOWER WINDOW SWITCHREMOVAL & INSTALLATION (TT)
2001 Audi A6 Avant Quattro
Removal & Installation (TT)
2001 Audi A6 Avant QuattroSECTION Removal & Installation (TT)
- Remove screw cap from middle of door panel by inserting a small pin through hole on bottom of switch trim. Press pin and lug slightly up and at same time turn screw cap counterclockwise and remove cap. Remove screw under cap. See Figure and Figure . Unclip 7 retaining clips. Lift door panel up and remove from door.
- Remove cable from inner door handle. Unplug electrical connectors. Remove one nut and remove inner door handle. Remove harness connectors from power window switch. Unclip power window switch from door panel and remove.
- To install reverse removal procedure. All clip locators must be clipped in place before installing door trim. When installing door handle cable, make sure hook is facing upward.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.