Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSAUDI2001A6 AVANT QUATTROREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSON BOARD DIAGNOSTIC (OBD) - CENTRAL LOCKING SYSTEM, MEMORY SEATS, ULTRASONIC INTERIOR MONITORCENTRAL LOCKING SYSTEM, ON BOARD DIAGNOSTIC (OBD)CHECK CONTROL MODULE VERSIONS (FUNCTION 01)
2001 Audi A6 Avant Quattro
Check Control Module Versions (function 01)
2001 Audi A6 Avant QuattroSECTION Check Control Module Versions (function 01)
- Press buttons -0- and -1-.
Indicated on display:
Fig 1: V.A.G 1551 Scan Tool (ST) Display - Central Locking System, Check Control Module Versions (Function 01) (1 Of 6)
- Confirm entry with -Q- button.
- Indicated on display (vehicles with no anti-theft alarm):
- Indicated on display (vehicles with anti-theft alarm):
Explanatory notes on display:Β
- 4B0962258D: Number of central locking control module
- 4B0962258E: Number of central locking control module
- Central locking: Component designation and version
- Central locking, ATW: Component designation and version
- Dxx: Software version
- Code 4672: Coding. See CODE CONTROL MODULE (FUNCTION 07)Β .
- Code 4682: Coding. See CODE CONTROL MODULE (FUNCTION 07)Β .
- WSC 06812: Workshop code
- Pressing --> button effects return to basic function.
Indicated on display:
Fig 4: V.A.G 1551 Scan Tool (ST) Display - Central Locking System, Check Control Module Versions (Function 01) (4 Of 6)
- Press buttons -0- and -6- to end output.
Indicated on display:
Fig 5: V.A.G 1551 Scan Tool (ST) Display - Central Locking System, Check Control Module Versions (Function 01) (5 Of 6)
- Confirm entry with -Q- button.
Indicated on display:
Fig 6: V.A.G 1551 Scan Tool (ST) Display - Central Locking System, Check Control Module Versions (Function 01) (6 Of 6)
- Switch off ignition.
- Disconnect connectors to V.A.G 1551 Scan Tool (ST).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.