Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSAUDI2001A6 AVANT QUATTROREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSON BOARD DIAGNOSTIC (OBD) - 2001 AND UPINSTRUMENT CLUSTER, ON BOARD DIAGNOSTIC (OBD)CODE CONTROL MODULE (FUNCTION 07)PROCEDURE

2001 Audi A6 Avant Quattro

Code Control Module (function 07): Procedure

2001 Audi A6 Avant QuattroSECTION Procedure

Initiate output Diagnostic Test Mode of instrument cluster. See INSTRUMENT CLUSTER ON BOARD DIAGNOSTIC (OBD), INITIATING .

Display on VAS 5051:

Fig 1: VAS 5051 Tester Display - Code Control Module (Instrument Cluster) (1 Of 4)

Courtesy of AUDI OF AMERICA, INC.

Select diagnostic function "07 - Code Control Module" in selection -1-.

Display on VAS 5051:

Fig 2: VAS 5051 Tester Display - Code Control Module (Instrument Cluster) (2 Of 4)

Courtesy of AUDI OF AMERICA, INC.

Enter code word Max. input value = 32767

Enter 5-digit coding in button field -2- according to coding table. See CODING VERSION FOR ADDITIONAL EQUIPMENT . If necessary, insert zeros in front.

Example:

Desired input value: 2266

Keypad input: 02266

Press -Q- button to confirm input.

Display on VAS 5051:

Fig 3: VAS 5051 Tester Display - Code Control Module (Instrument Cluster) (3 Of 4)

Courtesy of AUDI OF AMERICA, INC.

Coding will be performed

Wait until the next indication appears on display.

Display on VAS 5051:

Fig 4: VAS 5051 Tester Display - Code Control Module (Instrument Cluster) (4 Of 4)

Courtesy of AUDI OF AMERICA, INC.

Coding in vehicle system performed
Control module identification with new coding
(previous coding in parentheses)

End function "07 - Erase DTC Memory" by pressing <-- button.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.