Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Read Measuring Value Block (function 08): Notes
2001 Audi A6 Avant QuattroSECTION Notes
NOTE:
- For A/C Control Heads -E87- with part number up to and including index letter "G" and with index letters "P", "Q", "R" and "S", there are 12 measuring value blocks, each with 4 measuring values (display fields).
- For A/C Control Heads -E87- with part number and index letters "H", "J", "K" or "L" and from index letter "T" as well as index "AE", "AF", "AG", and "AH" there are 13 measuring value blocks, each with 4 measuring values (display fields) (-E87- for vehicles up to model year 2001).
- For A/C Control Heads -E87- with part number and index "AA", "AB", "AC" or "AD" and from index "AJ" there are 19 measuring value blocks with each 4 measuring values for the service department (-E87- for vehicles from model year 2002).
- With model year change 2001 to 2002 the A/C system control will be changed over. For Audi allroad, the changeover of the A/C system is not performed with the model year change 2001 to 2002, instead it is a running change (implementation open, for vehicles with 4.2 Liter engine with start of production).
- Regulation of the air conditioning remains functional during the On Board Diagnostic (OBD) Read Measuring Value Block function 08 and the current measured values are displayed.
- Display groups with measuring values for actuator (positioning) motors show the current actual or specified values and the learned values (stored during the last basic setting) for the end stops of the individual positioning motors
- The positions of the positioning motors and flaps can be changed during the OBD using the control buttons on the A/C Control Head -E87- and the current and specified values are displayed on the scan tool display.
- When the printer is switched on, the contents of the display will be printed out on the scan tool log.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.